FILTER BELT OIL RECOVERY SYSTEM
The results of a systems development program (Phase I) for preliminary design of a high seas oil recovery system are presented. Requirements were to project a system capable of recovering 2000 gpm of oil with a low water content. Oil would be recovered from the water surface by two continuous filter belts mounted in the center of a catamaran hull. The filter material retains oil but allows water to pass through freely. An additional oil/water separation system is not required. The system would include a 2000 gpm oil transfer system for offloading recovered oil. It may be used in conjunction with oil containment booms, floating oil storage bags, barges, or small tankers. The system would be designed to operate in waves up to 5 ft. average height. The system would be required to be transported by land vehicles or C-130 cargo aircraft. This report describes basic filter material performance testing, model basin testing, filter belt development, subsystem requirements definition, and preliminary design.
Martin Marietta CorporationAerospace Division
Denver, CO USA 80201
- Moses, R O
- Blackstone, S L
- Publication Date: 1971-12
- Pagination: 308 p.
- TRT Terms: Oil recovery equipment; Oil spill cleanup; Water quality management
- Uncontrolled Terms: Oil separators
- Old TRIS Terms: Oil recovery systems; Oil removal equipment
- Subject Areas: Environment; Marine Transportation;
- Accession Number: 00095316
- Record Type: Publication
- Source Agency: National Technical Information Service
- Report/Paper Numbers: USCG-D-82-74 Final Rpt.
- Contract Numbers: DOT-CG-14058-A
- Files: TRIS
- Created Date: May 29 1975 12:00AM