Evaluation of the Two Methods of Determining Bulk Density of Sand: Tapping Fork Test and Vibrating Table Test

Ocena metod badania gęstości objętościowej szkieletu gruntowego piasku wykorzystujących widełki wibracyjne i stół wibracyjny

The aim of this research is to compare and evaluate the methods used for determining the maximum bulk density of sand ρdmax. Two methods were considered: tapping fork test and vibrating table test. They were compared in terms of the efficiency of compaction and the repeatability of results. The tested material was quartz sand. The tapping fork test was carried out independently by two lab workers. While the tapping fork method proved to be satisfactory in terms of compaction efficiency (as demonstrated by the mean bulk density of ρdmax=1.805 g/cm³), it was not as good in terms of repeatability (3.35% of relative error) and showed sensitivity to human factor. The second test was performed using a vibrating table with inertial excitation. Selecting an appropriate frequency of vibrations proved to be a key factor. Too low frequency resulted in poor compaction and in case of too high frequency the density was increasing and decreasing alternately. The frequency of 39 Hz was found to be the optimum value, producing the average density of ρdmax=1.795 g/cm³ and 1.56% of relative error after vibrating for the standard time of 12 minutes. Even seemingly small variations of relative error between the analysed methods resulted in considerable variations in the degree of compaction of the tested sand. Therefore, the selection of the method is so important due to the criterion of test objectivity.


  • English
  • Polish

Media Info

Subject/Index Terms

Filing Info

  • Accession Number: 01600435
  • Record Type: Publication
  • Files: TRIS
  • Created Date: May 9 2016 3:40PM